Rosco 05781 Paint Fluorescent Orange1Quart

Rosco Paint 05781 is one quart of Fluorescent Orange which is part of the Rosco series of special effects paint. Available in 9 brighter than normal colors which fluoresce vividly under ultraviolet lights, Rosco Fluorescent paints can create a wide range of exciting effects. They can be used to create special effects using ultraviolet Blacklight or combined with other Rosco paints to make normal colors more vibrant. Fluorescents use the same high quality, water base, vinyl acrylic binder found in Off Broadway paints. It is suitable for use on most surfaces and for interior and exterior* applications. Try using Rosco Fluorescent paints when matching the brightest colors in the Pantone Color Matching System or to achieve astounding 3-D effects.

Surface Preparation: Surfaces should be clean, dry and free from dirt and grease. Prime porous surfaces, except fabrics, using Rosco Tough Prime. If painting a new plaster surface, prime wall with a commercial primer/sealer designed for raw plaster. Then use Rosco Tough Prime as a final preparation. Use a white base coat to achieve the most dramatic color effects.

Application: Stir contents before use. Do not shake. Apply by brush, roller, or spray gun. Apply in thin uniform coats, using a good quality brush or roller. Use overlapping strokes, keeping a wet edge.

Rosco 05781 Specifications:

• Finish: Matte
• Solvent: Water
• Binder Type:Vinyl Acrylic
• Dilution: Fluorescent Paints should be used straight out of the can. They can be diluted with water if necessary, however this will reduce the hiding power of the paint.
• Film Thickness: 2 mil. dry film.
• Coverage: Approximately 300 sq. ft. per gallon.
• Avg. Dry Time: At 75°F (24°C). Dries to the touch in 30 minutes. Can be recoated in 1-2 hours.
• Clean-up Soap and water.
• Shelf Life Minimum 24 months.
• NOTES:
• * Fluorescent pigments will degrade from prolonged exposure to ultraviolet light. Avoid direct sunlight where possible.
• ** Invisible Blue is a milky white paint that fluoresces to a pale blue under blacklight. When painted over light colored surfaces, Invisible Blue is difficult to detect. However, it can be seen when painted over dark or black colors.
• All technical data, recommendations and service are accurate to the best of Rosco’s knowledge. Rosco assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.

NOTE:

Image shown is a approximate digital representation of the Rosco Fluorescent Paint color chip produced.